Support For Asterisk E1 cards

geniune

It would be graet If you add support for asterisk cards like FXO / FXS / E1

Thanks

pythonpoole

Well I don't know about Asterisk cards, but when you use Carousel in combination with Axon, you can interface with many hardware telephony boards such as CAHTA, CallURL and Synway cards.

geniune

Its a single port 30 cahnnels card. It habdles 30 channels over a single R 45 port.

you can find information at www. sangoma.com

model a101

pythonpoole wrote:

Well I don't know about Asterisk cards, but when you use Carousel in combination with Axon, you can interface with many hardware telephony boards such as CAHTA, CallURL and Synway cards.

mperdue

geniune wrote:

Its a single port 30 cahnnels card. It habdles 30 channels over a single R 45 port.

you can find information at www. sangoma.com

model a101

The asterisk card's are actualy by digium (www.digium.com) I have a 4 port pri card and a 1 port pri card. I'm not happy with the asterisk software. I posted in another forum if I could allow my assterisk box to just be the sip gateway and then rely on axom to do call routing/registrations etc etc in antohe rpost.

megatech

geniune wrote:

It would be graet If you add support for asterisk cards like FXO / FXS / E1

Thanks

You can plug a T1 into a Total Access 924e router which has 24FXS ports - plug these ports into your AXON supported CAHTA analog boards - and everything works great. You can easily split your t1 into voice and data with this router - say you want 12 PRI and the rest as data.