JackE wrote:
If this info is in the manual, it would be helpful if you'd specified which section, rather than just saying "check the manual" - or, better still, specified how we can create those symbols. I've read through the manual very carefully, twice, and the only reference I can find is in the introduction, which says the software allows you to:
"Create repeat symbols like Segno and Coda"
Unfortunately, it doesn't say how you can do this, nor where to find the instructions, nor can I find any other reference in the user manual to either Segno or Coda.
My Point, exactly. It is in a pull-down menu, but, as I type, I forget which pull down carrot to use. If I can figure out how to find it, now, and return to type here, I will.
Ah, within a measure, right click and you should get a drop-down menu. TWELVE items down is "repeat", or from the bottom see, Measure Layout, Measure, and then, REPEAT. Click on REPEAT and see the various Coda, Capa Da Segno etc., options.