Selected region not at expected location

T._Hanson

This is an old thread, but I don't see other discussion of it so here's what I've observed. When I click at a given point to set the cursor, that is the playback position. However, when I stop playback at any point, even though the cursor appears to be at the place where I stopped, WavePad thinks my current position is the point where I *began* playback. If I try to select a region, it will be relative to the start of last playback, not the current cursor position. This is highly inconvenient when using playback to find a particular place. However I can apparently reset the cursor by using ctrl-G to set the cursor to the current visible position.

[deleted]

Hi T. Hanson,

Can you please let us know what version of WavePad you are using? WavePad should always play from the cursor position and never from the last played position.

Regards,

Ben

T._Hanson

Hi Ben. It's WavePad Masters Edition v6.02..

Again, playback always does begins from the current position.

However if I attempt to select a region by using shift-click, the start of the new selection is the point where I began playback, not the current position.

Hope that's clear. -- Trevor

[deleted]

Hi Trevor,

I am not able to reproduce the problem you describe. It's possible that this was an old bug and is now fixed. I would suggest downloading the trial of the new version and seeing if that solves your problem. If you still experience the problem then let me or support know.

Regards,

Ben